* 4 Channel Frequency Generator. * ESP32 Miicro Processor Controlled. * Independent 1.00 Hz to 50.00 KHz Frequency Range Channels * User Manual or Computer Programmable. * Runs independent of a Computer. * Unlimited Protocol Storage using a Micro SD Ram Card. * Wi-Fi Controllable. * Check Order Page for pricing, availability, delivery status, and Order Policy Agreement.
A basic programmable, square wave, 4 channel frequency generator that runs independent of an attached computer. Each channel’s frequency and duty cycle are independent from one another. Has two built in timers. One is for how long each frequency line will run and the other is for how long the entire program protocol will run. A protocol can consist of up to 275 frequencies and duty cycles for each of the 4 channels. A micro SD ram card can store up to 10 fix named and callable files each can contain up to 275 protocol lines. The SD ram can store all the user information and technical files for the generator with room to store thousands of user named protocol files. Because of the Open Source nature of the project, all technical information including PCB layout, schematic, source code, and basically everything one would need to completely duplicate the project is preloaded on the SD card. This unit comes Wi-Fi ready and can be start/stopped with a smart phone or your computer. The generator has a user selectable jumpers for either 5 volt or 12 volt output level settings for each of the four channels. There are 3 modes of operation; Simple, Protocol, and Sweep modes. These modes are define in the PDF documentation found at the bottom of this webpage.
Since inception of the concept of using a function generator as part of a Rife system, I have opened sourced my concepts on the internet long before Spooky existed. As a one person shop and still working it was alway hoped that someone would pick up on the idea and make a user programmable Rife machine from a function generator. You can look at my YouTube site ”gskempe9” to see some initial video postings of this idea. Then Spooky came along and I went to heaven by buying a dozen Spooky(s) over time. Spooky was and is a great product but I always thought it a bit lacking because of how it linked the duty cycle and several other parameters with the protocol verse the frequencies within the protocol.
I became a believer in the Rife concept along with the Bob Beck blood electrification device when a family member and myself found a use for this technology. I became a believer because the technology worked for us and is why I’m still persuing trying to help others with my Open Source projects.
My fortie has always been computer programming and with the advent of today’s MPU devices, it has been a fun rollercoaster ride playing with these devices. A lot has been learned in both hardware and software design and it is my intent to continue with new project designs that incorporate today Micro Processing Units. It is sincerely hoped that this unit is used as a stepping stone by others to build more sophisticated devices to help the human condition.